Click Strip System

• Click rail mountings, ridge end rail cap, widened eave end rail cap for roof and façade
• Perfectly fitting components
• Reduced tool and machine use
• Time-saving surface assembly
• Rain proof long seam connection from 3° slope
• Wooden rail replacement including binding with binding strips
• Course lengths up to 20 m
• Extreme efficiency, especially for non-ventilated roof superstructures
• Higher level of pre-finishing simplifies calculation

Click Strip System

The strip system is the most traditional standard modern metal cover technique. With the click strip system, courses and protective caps are produced ex works up to a length of 6 m, in a single process. For production of longer courses, mobile roll shapers are available on loan. The pre-shaped click strip cap is also available in the standard length of 3 m. The system is suitable for roof slopes from 3° with no additional sealing-technical measures required. Increased demands make use of structured separators or weather and rain proof under covers essential.

Continuous development

For further optimisation of the click strip system, three further system components have been developed: the click rail holder, finished in 1.0 mm thick galvanised steel, serves as a replacement for the previously used wooden rail and corresponding bindings and binding strips, as the holder also form the binding profile for the rail cap course and carrier. At the bottom end, the rail cap is flared to allow slight overlap of the individual caps. In conjunction with the factory pre-finished ridge and eave end profiles, assembly of the click rail holder has been significantly rationalised.